Koi Pond Bottom Drain Discussion

3 inch bottom drain and 4 inch bottom drain

The purpose of a koi pond bottom drain is not so much to drain the pond as it is to remove the debris from the bottom of the pond into the filter where it can be removed from the pond system. The bottom drain should be drawing water into the filter 24 hours a day. With this purpose in mind, koi pond drains have a unique design. They need to allow leaves and debris to pass through it without allowing the fish to be sucked up at the same time. The most successful type of drain for this application is an open drain with a cover over it. (see drawings)

Bottom Drain Height

This type of drain has been very successful in the past but it has its short comings. One problem is that it can be hard to service if leaves get wedged between the drain lid and the pond surface. If you lift up on the drain cover to allow the leaves to pass through and the lid comes off, it is impossible to reinstall the lid without going into the pond. That is a real problem in a deep pond, especially in the winter time.

Another problem with this type drain is that they can be hard to install. If you are building a concrete pond you will need to accurately estimate exactly where the bottom contour of the bond will be so any debris on the pond bottom will gently flow into the bottom drain. If you plumb the drain too high or too low it will greatly reduce the efficiency of the bottom drain. (see drawing)

The final problem is that it is very hard if not impossible to pressure test this type drain after it is installed. You can install a balloon type plug in the line but our experience has been that it is very hard to get them to hold 30psi for testing.

The Advantage Bottom Drain Covers solve each of these problems.

bottom drain setup

  • Easy to service

If debris begins to collect around the Advantage Bottom Drain Cover you can simply reach in the pond with a pool pole and net and slide the cover to one side, dislodge the debris and then slide the cover back over the bottom drain hole. (The Bottom Drain Cover with air diffuser has a hose that connects it to the air supply which is flexible enough to allow you to slide the drain to the side without disconnecting the air pipe from the cover.)

  • Easy to install

With most other type bottom drains it is very hard, if not impossible; to plug the bottom drain pipe for pressure testing once the drain is installed. With the Advantage Drain Covers on concrete ponds you can simply stub up the bottom drain pipe, cap it off and once the pipes are pressure tested, leave them under pressure until the pond is completed to make sure no pipes are damaged during construction. The last thing you do, after plaster and before adding water is to cut off the bottom drain pipe level with the pond bottom and place the drain cover over the pipe.

Pricing, Specifications, and Installation:

bottomdrain-standard-card bottomdrain-air-card bottomdrain-retro-card